- Kit Brand New
- Brand
- Aftermarket Products (24)
- Am Autoparts (23)
- Ap Auto Parts (20)
- Bosch (22)
- Brakemotive (18)
- Buyaparts (17)
- Detroit Axle (26)
- Dewalt (32)
- Exedy (33)
- Ford (62)
- Gates (46)
- Luk (44)
- Makita (22)
- Milwaukee (19)
- Oe Quality (119)
- Racemmi (18)
- Rymec (81)
- Select Automotive (18)
- Venalisa (24)
- Voilamart (27)
- Other (3353)
- Clutch Kit Type
- Heating System
- Material
- Power Source
- Type
- Air Filter (40)
- Boiler Parts (12)
- Cabin (17)
- Canister / Cylinder (13)
- Clutch Kit (165)
- Control Arm (12)
- Control Arm Kit (25)
- Conversion Kit (24)
- Enclosed Powered (13)
- Gel Nail Polish (12)
- Headlight Set (12)
- Kit (19)
- Kitchen Equipment (11)
- Service Kit (53)
- Sinks (13)
- Suspension (14)
- Timing Belt Kit (29)
- Timing Chain Kit (41)
- Timing Kit (37)
- Turbo Kit (32)
- Other (3454)
Pre-Wired Victron 12V Electrical System Full System / Board 2
Take the hassle out of your van conversion electrics with this pre-wired Victron-based electrical board, designed to be modular, expandable, and easy to install. All components are professionally mounted, fused, and pre-terminated - simply mount the board, connect your batteries and inputs, and you're ready to go. Built using genuine Victron Energy equipment. Designed for future upgrades solar, hook-up, inverter, etc. Saves hours of wiring, planning, and fault-finding. Ideal for DIY converters or professional builds. Board 1 - 12V DC Charging & Distribution. All cabling, fuses, terminals included. Ideal for: Simple leisure battery setups or first-stage builds. Board 2 - Full Off-Grid Charging System. Victron MPPT Smart Solar Controller. Ideal for: Fully off-grid vans with solar + hook-up capability. Board 3 - Hook-Up Only System. Ideal for: Vans using campsite hook-up only. Board 4 - Solar system (Does not include solar panel).
Victron Smart MPPT charge controller. Board 5 - Inverter Add-On (Optional). Renogy Inverter (size to be agreed).
Integrated safely into existing board layout. Mounted on durable board (phenolic / equivalent - moisture resistant).
Designed to be expanded later without rewiring the whole system. What You Need To Do. Mount the board in your van. Connect DC-DC to starter battery. Connect Neg busbar and isolator fuse to leisure battery. Connect solar / hook-up if applicable. AGM / Lithium compatible setups. This listing is for the electrical board only. Does not include leisure battery.DC/DC system comes with 1 X 6M 16mm2 cable for starter battery input with fuse. 240V system comes with 2 X 10M 240v cable runs for 240V outlets & 1 X 5M 240V cable run for 240V inlet. Solar panels can be included but will be sent separately, won't be pre wired PV side, extra P&P. Boards will be either 2ft x 4ft (if no future proofed inverter) or scribed to wheel arch. I build these systems the same way I fit them in real vans - clean, safe and future proofed.
No cheap shortcuts, no messy wiring, no guesswork.